Ultimaker ABS Red for the top part Ultimaker ABS Grey for the bottom part Printed with the Ultimaker 2 Extended+. I used a Brim for both parts in combination with Tesa gluestick just in case. Nozzle temperature 255 Bed temperature 100 Layerheight 150 micron bed level Killer bed leveling! All other settings, including print speed were set to default normal settings. for ABS material in Cura 2.1.2. As you can see I haven't done any tweeking with Cura settings, was just curious how it would come out with 150 micron and to see how the adhesion would be. I came to the conclusion that using a Brim wasn't required. The power of Tesa is real! The two parts are a perfect fit as it was designed to be. Great job and thanks to "0110-M-P"!