YouMagine

Information Comments Technical Files Builds Add build

Comments

You need to be signed in before commenting.

Marcus Wolschon

over 9 years

<p>What do you mean by "4 ball casters "`?</p><p>608ZZ ball bearings?</p>

sinan

over 11 years

Thanks owen, that should work. Cura ignores very small features by default, so it may be a little tricky. I don't remember the thickness but it was a low quality print. It was probably 0.8 or 1.2 mm.

owen

over 11 years

<quote>The weakest point of this design is the shaft of the side gears. It would be nice if I could set the fill density of only these parts to 100%.</quote> Hi sinan If you want to make an area solid you can put a void or more in you model there. If you put a 0.1mm hole inside your model and you have 1.2mm skins set in Cura you will get a 2.5mm column of solid plastic there (the hole in the middle is so small it will virtually get filled) If you put these holes close enough together they will all join up. You can check in Cura first. You also need to tell users what skin thickness to print at in your instructions.

sinan

over 11 years

I just wanted to edit it later, thanks :) This thing makes a relatively slow rotating motion (about 100-300 rpm ) and the orbit radius is 1 cm. If the radius is reduced and a higher rpm motor is used, the same design could be used for vibration generation. Maybe the side gears should be smaller too.

UltiErik

over 11 years

Cool! By the way, right now the design isn't published yet. So only us YM Admins are able to see it. Perhaps you forgot? It's not very clear, but we will make this process more clear a.s.a.p.! By the way, someone should print it and strap this to it: http://www.thingiverse.com/make:3332

Orbital Shaker

By sinan

Comments

License

Tags

sinan

YouMagine

Orbital Shaker

By sinan

Add To Collection

Comments

License

Tags

sinan

YouMagine