Printed on MOST Delta 3D Printer: http://www.appropedia.org/Athena_Build_Overview I used OpenSCAD to design the part. There is an engraving at the top of the wedge that can easily be adjusted in the code. The ramp of the wedge tends to peel upwards; HIGHLY recommend adding a raft to increase platform adhesion. Note the wedge uses the full width of the MOST Delta printer. PLA 1.75mm Hatchbox Fill Density: 30% (tested up to 495 lbs) Print Speed: 50 mm/s Layer height: 0.2 mm Shell Thickness: 1 mm Bottom Thickness: 0.3 mm Recommended: Raft (for bed adhesion of the ramp)