has all holes for rpi and pcb board for lcd (ordered mine from ebay) also have room for a battery or two, can be printed supportless if printer has cooling fan for the usb and ethernet areas, all round holes for now will need to be slightly reamed for clearence issues(wether its my printer settings or the actuall sketchup file im not sure yet), last usb has slight clearence issue, i just trimmed it back with razor, and until i edit in sketchup again the supports between the usb's and ethernet port are too weak and will break(keep in mind this is quite a minimal thing and is mainly only cosmetic) none the less will be fixing on tues. i have the lid printed but i feel it needs couple adjustments first, im guna make it support less and alittle more eye pleasing i should have it posted on this page by tues.