Venus De Milo with built in Supports
By williamblake
Free
It's free to download
Information
Venus De Milo with built in Supports
By williamblake
at 2024-05-06
I wanted to print this without bed supports. Used Meshmixer to add supports in the most acute areas. Printed great. Simply snip off supports at point.
Printed at 0.3, no infill, printed about 9 inches tall.
I "reduced" original 3d scan from CosmoWenman in MM.
# Print Settings
Printer: Monoprice i3 Plus
Rafts: No
Supports: No
Resolution: 0.3
Notes:
Used a brim only.
53 objects
6 Followers
Joined about 3 years ago
USA
3d printer for over a decade. Advanced 2d and 3d design. Engineer. I closed my thingiverse and prusaprinters accounts due to political censoring of designs whilst allowing violent content to continue.
Free