Oke that is weird.
That it printed 1 part an than the second one is a setting you can choose in cura. But it should work without crashing in to the first part.
But i don't understand what went wrong.
Apologies again.
Dan M
about 2 years
The fan ducts are stock. What was strange was that normally, my printer would do all 3 parts together but in this case, it completely finished the printer mount and then lowered the table to do the other parts after
undeviljur
about 2 years
Sorry to hear that the print head crashed into the part.
Did you by any chance have a bigger fan duckt than the stock ultimaker 2/2+?
Hope you still enjoy the spool holder I designed.
Dan M
about 2 years
I built this using the gcode files provided. The quality of the prints was excellent. One issue. When I printed the gcode for the short tube/printer mount/T piece, it printed the "printer mount" first and then tried to print the short tube and T piece after. Needless to say, the hot end crashed into the short tube. I used the parts separately and it was all good
MakeThings3D
over 8 years
No Problem then I Print it in PLA Thanks :-)
undeviljur
over 8 years
Marc M, Yes I did print it in PLA. The Ultimaker 2 doesn’t compensate for the amount of ABS shrinkage. In my opinion there is no good reason to print this design in ABS (will also add this to the description)
MakeThings3D
over 8 years
I tried it to print in ABS but the Tolerances to small! Have you print it on PLA?