UltisandervG This is a Cura Project file that is designed for UM3 Dual Color Printing. The hair is attached to a tube. Cut the hair off the tube with a sharp knife carefully. Then cut the hand supports with some scissors or side cutters and slide UltiSandervG out of the tube. You will need to trim the hair to length and it with some hot water from the tap ( 60deg or so ) to shape it. Terms and conditions: 1. The amount of hair on the UltiSandervG is not a true representation. 2. The Hair on the UltiSandervG Does not grow. 3. Although the UltiSandervG is taller then the Standard Ultibot, Its not a true representation of SandervG's actual height. 4. UltiSandervG Cannot hear complaints about the forum. 5.The UltiSandervG does not give political responses to issues raised. 6. You Must style the UltiSandervG's hair according to SandervG's Profile Photos and make sure his beard is properly trimmed. 7. SandervG's hair style and beard length may vary so you may need to print more UltiSandervG's to keep up with the current trend. 8. The UltisandervG Must not have a bad hair day. 9. Hair gel does not work on the UltisandervG. 10. UltisandervG must not have bald spots until SandervG has bald spots. 11. When Playing with the UltiSandervG you Must talk with a deep booming mainly voice. 12. The UltiSandervG Must not be engaged in explicit activities or used as a voodoo doll. 13. You must not Use Girly colors when printing the UltiSandervG. 14.The UltiSandervG is there to manage the community of your 3D prints. 15.The UltiSandervG may get homesick if not printed in Geldermalsen so you may need send him back from time to time or take him to visit. 16. Just like the real SandervG, The UltiSandervG like's to party, so please take him along with you.