<p><a rel="nofollow" target="_blank" href="https://www.youmagine.com/users/3d_nerd">3D_nerd</a>,<br></p><p>I see. Yep, how far through the bottom plate (the above the extruder) do your threaded thumb screws extend? Let me know and I can adjust the height of the stand-off for you.</p><p><br></p><p>-N</p>
3D_nerd
over 9 years
<p>Hi madeintaiwan,</p><p>thanks for reply, maybe I am wrong but on my UM2 there is no spacer at the top, please take a look here:</p><p><a rel="nofollow" target="_blank" href="http://i.imgur.com/397LhMs.jpg">http://i.imgur.com/397LhMs.jpg</a></p>
madeintaiwan
over 9 years
<p>Hey <a rel="nofollow" target="_blank" href="https://www.youmagine.com/users/3d_nerd">3D_nerd</a>, </p><p>This is a replacement for the spacer and the push fit retention clip in one. Normally the UM2 has a black plastic spacer between the knurled ends and the top most plate of the extruder. This part is the same size as the standard spacer with the added benefit of having a 'c'clip that rotates into place. It uses the stock hardware otherwise (no new parts required). </p><p>-N</p>
3D_nerd
over 9 years
<p>Hi,</p><p>I want to know what 4 skrews are used here. This clip goes underneath the front right skrew of the print head. So this skrew has to be longer than the stock skrews to get space for the clip underneath - or not?</p>
madeintaiwan
over 9 years
<p>Thanks <a rel="nofollow" target="_blank" href="https://www.youmagine.com/users/reibuehl">reibuehl</a> !</p><p>Just put up a 1.5mm thick version. </p>
reibuehl
over 9 years
<p>Great Design! Do you think you could also publish a version with the same hight as the original one?</p>