See Main Information. This is for the front left and back right feet. Just mirror in the X plane for the other 2. Run a test off now, although I got a blocked nozzle half way, I've fitted what it did print and it fits fine.I've printed with following settings with good results:0.2 layer height, 50mm/s, ooze shield and wipe and prime tower enabled. Retraction ON. Fan set to 0 min, 100 max, on at 5mm. Flex PLA: 250 degrees, No fan for this lower part.PLA: 220, on at 5mm Z.No oil required for the Flex PLA for me, feeds fine at this temperature.As you can see from photos of the ones I have printed, I still have a problem with oozing. If anyone has any suggestions on how to improve on this, please do let me know in the comments. Also, after just fitting them, I can confirm they fit like a glove.