Ultimaker 2 Spool Holder Plug

By EldRick

10
17
Free
It's free to download

Information

Ultimaker 2 Spool Holder Plug

By EldRick

If you remove the rear-mounted spool-peg on the back of an Ultimaker 2 or later, it leaves three oddly-shaped holes. This plug should be a light press-fit from the back of the UM2 and fills the holes flush to the inside of the build chamber. If it fits too tight or too loose, adjust the feed rate by a few percent.
3 objects 4 Followers 975 Downloads
Joined over 10 years ago
Enjoy a 10% sitewide
Discount at checkout
Get a 10% Discount