Free
It's free to download
Information
Ultimaker 2 Front Window - No drilling required
By Emanuel
at 2016-07-14
This cover is lifted into place, sliding the top brackets behind the front plate of the printer. The lower brackets can then be pushed in and the cover is lowered to rest on the 2 bottom brackets.
Removal is very easy, just lift and tilt the bottom part away from the printer then lower again.
Technical
4mm Acrylic sheet, milled or laser cut to size.
4 3D printed ABS brackets
8 M3 x 10 screws
8 M3 nuts
The long brackets are mounted to the top, the short go on the bottom.
Comments
You need to be signed in before commenting.
Lindsen13
over 5 years
License
YouMagine
a MyMiniFactory company
© 2024 YouMagine. All rights reserved. 2 Berners Road, Islington, London, N1 0PW, United Kingdom
Free