Everything prints at 0.2 mm layer height. Set your line width to 0.45 mm, as the pattern design is optimized for it. Bridge settings must be on. The board, its border, and its patterns are provided as separate models, so that everything prints in your favourite colour palette. The same goes for the piece and its pattern. Import the board into your slicer and then import the corresponding border and pattern as parts. Use the same procedure for the piece base and its pattern. The board and the piece base are 3 mm high, while the board border, the board pattern, and the piece pattern are 0.4 mm high. When using a single nozzle printer, you can issue a colour change command at the 3.20 mm mark to switch to a new colour.