YouMagine

Cinezaster

almost 9 years

It's a pity it is not for Ultimaker original and not for dual extrusions. If your already modifying it, keep on going :-p. Great job. Question: Does the spinning fan has an effect on the airflow?

Loboptlu

almost 9 years

Hi would very interest me . I have a ultimaker2 go so every cm counts unfortunaly. 😟

duckgogogo

almost 9 years

hey loboptlu, i have already began to modify the fanduct, try to balance the flux on two sides by increase the pressure loss of right side. and shrink the width.

Loboptlu

almost 9 years

You know that saying only works for monopols as soon as there are alternatives you ll get dumped as a supplier . Your buddy might be wise but i think that time he was under some bachus spirit ;). Trade school 101 always try to supply the customer what he wants as long as its reasonable and never should you not listen to customers . Ok i know this is not a customer seller relation ;) but if ever you want to become a trader or similar throw that saying into a grinder and never remember it again. The only ones who can pull that of are Apple because their fan boys dont think rationnally.

super fan duct for ultimaker -- delicious clam

By duckgogogo

Comments

License

duckgogogo

YouMagine

super fan duct for ultimaker -- delicious clam

By duckgogogo

Add To Collection

Comments

License

duckgogogo

YouMagine