I chose to solder new wires, and place heat shrink tubing. This is not required, there should be ample room for the excess wire, underneath the fan inlet cowling. I also chose to paint the fan black, so it does not draw more attention. It is barely visible inside the inlet cowling. ___________________________ Must be printed with supports. Print in material which will not soften under direct sunlight (I chose PETg). The included Gcode file is: * Prusa MK3/S Firmware version 3.7.2 * Temps for PET/PETg * 0.15 Speed profile, 150 travel, 50 perimeter * Supports from Build Plate with Z contact of 0.15mm