PLA Print instructions: Bell: Prints in vase mode with the following settings: - Layer height: 0.1 mm - Line width: at least 0.55 mm (this is doable with a 0.4 mm nozzle without any further adjustments to your print settings) - Bottom layers: 0 - Brim Rope and Holly Leaf units: - Layer height: 0.2 mm - Infill: 0% - Perimeters/walls: 2 If using PrusaSlicer, disable “Ensure vertical shell thickness” under Print Settings > Quality. This setting is visible in Advanced and Expert modes. Ribbon unit: - Layer height: 0.15 mm or lower - Infill: 0% - Perimeters/walls: 2 The connector prints at 0.2 mm layer height. Use enough perimeters/infill to make it sturdy if you intend to disassemble the ornament.