Wanting a better frame to make a curved backdrop for photographing small items i've designed this frame assembly.The frame allows for card up to 1.2mm thick to be used, it can be used either way around to give differing angles with another exit for a different angle.For the other end mirror the frame in the slicer.Print:-1 x Photo Booth End Plate1 x Photo Booth End Plate (Mirrored)4 x Photo Booth Clip (shown in Blue)2 or 4 x Photo Booth Foot ( depending if you want 1 or 2 per frame)Each end frame has two positions for the foot to be located in either print one or two feet depending on your preference, the foo swings out and helps to stabilize the end frame.In addition at the bottom corner are two holes 1 for each typical filament size. that can be used to hold frames together with a length of filament the tapered section in the corner can be used to trap a cord again to hold the frame.To use, just slip the card etc in from one end of the frame and gently push it to the desired location.