Nexus 5 Bumper

By MakeALot Chat with Creator

6
0
Free
It's free to download

Comments

You need to be signed in before commenting.
MakeALot
MakeALot
about 9 years
<p>Thanks for the note. Most people find it a very tight fit, it depends on the dimensional accuracy of your printer. The finished printed part should be 142.2 by 72.9 by 10 mm.</p>
GrahamRowe
GrahamRowe
about 9 years
<p>Hey, just thought I'd leave a bit of advice for anyone printing this. I just printed it last night and found that it was a touch to big for my phone. You could either scale it down by about 1mm in both x and y or use this as a base to make a more protective full case. This is my plan as this current design also doesn't allow the buttons to be pushed at all.</p>

MakeALot

25 objects 47 Followers 47 Downloads