YouMagine

Information Comments Technical Files Builds Add build

Comments

You need to be signed in before commenting.

Garrett Lord

over 4 years

Steve G, thanks for the suggestion. I’ll make those changes and post an update.

Steve G

over 4 years

To eliminate supports on the right brow arm connector could the connection be swapped top-bottom? Then arm can then be flipped on the print bed.

Garrett Lord

over 4 years

Thanks, @emanuelec! I've added the Europe 4-hole as individual pieces and as a complete set.

Garrett Lord

over 4 years

@emanuelec I've uploaded the Europe 4 hole, as individual pieces and as a complete set.

emanuelec

over 4 years

Thanks for the great work! When do you think the Euro 4 hole will be available?

Garrett Lord

over 4 years

Is anyone else having an issue with the pegs feeding through the holes? I can see if making the holes bigger will help. I just received an order of PLA today, so i can test it with that. I've been using PETG, so my prints have all turned out relative durable.

JayArgh

over 4 years

I just tried this on my Qiditech X-one2, using QIDI-Print for slicing, printed in PLA. QIDI-Print for some reason would not let me put all four pieces on the same lay-out, so I printed in two batches. The studs that connect all the pieces together were quite brittle when printed in PLA, they all snapped with a little bit of pressure. I recommend anyone using PLA clean out the holes for the studs well, so as not to snap them on assembly and use glue when assembling. Let the glue dry before trying it on. Otherwise, the design printed fine and

fredrik.simu@gmail.com

over 4 years

I have a FlashForge Finder with a 14x14cm bed. Currently I'm down to 1.26 minutes using raft, but I'm going to try without the raft. Any suggestions on layout much appreciated.

MariaLovelöv

over 4 years

Great! Thank you! I have a Flashforge Finder, the bed size is 140 mm x 140 mm. Do you think I can fit more on there?

Garrett Lord

over 4 years

What printer are you using? Since there are many bed sizes, I left the pieces individual. If it’s bigger than 100mm square than you should be able to place multiple on the same print. I’d also be happy to provide pre-located parts of you provide a bed size.

fredrik.simu@gmail.com

over 4 years

Does anyone have suggestions on how to place the parts as close together as possible to insure faster print? What would be a good layout?

Garrett Lord

over 4 years

The Sweden 6 hole model has been added. I'm working on the Euro 4 hole now.

MariaLovelöv

over 4 years

Thank you so much! That would be awsome!

Garrett Lord

over 4 years

Sorry about the delayed response, I've been setting up another 3D printer. I'll have that set up for you both in a few hours, MariaLovelöv and krismcewan.

MariaLovelöv

over 4 years

Hi Garrett! Would you be able to do one modifyed for the Swedish model aswell as provided from 3DVerkstan? I’ll then begin to produce here in Sweden!

krismcewan

over 4 years

Can you do this for the 4 hole Euro model. this woudl fit on my smaller printer.

Modular Protective Visor

By Garrett Lord

Comments

License

Tags

Garrett Lord

YouMagine

Modular Protective Visor

By Garrett Lord

Add To Collection

Comments

License

Tags

Garrett Lord

YouMagine