Post-Printing: You need a holder for a thicker or higher remote, then use the scaling function of your Slicer for minor adjustments. How I Designed This: That's why I've made simple remote control holders in three variations: There are more and more, these little flat remote controls for all sorts of LED gadgets. Remote-controlled LED lighting is available in so many variations for home, car, camper, boat or whatever. But what almost does not change at all ... these small remote controls in the same format of: 7x52x85mm. Sometimes they are a bit thicker and a bit higher, but almost always these things are lying around somewhere and you have to look for them first. So why not finally determine a permanent place for these remote controls?