YouMagine

Information Comments Technical Files

Comments

You need to be signed in before commenting.

Andrea Murru

about 6 years

Scaled up to 101% as Eondar suggested, worked perfectly with Coffee Lake!

Chri

over 6 years

@ SkyNETTestGames, sorry, can`t say if it will work with Coffeelake, i have no so cpu @ImpulsiveJames , sorry but won`t happen.

ImpulsiveJames

over 6 years

Any chance you'd consider an Ivy Bridge re-lid tool in the next few days? :) I'm de-lidding in about three days :) Thanks! James

SkyNETTestGames

over 6 years

will it go for the i7 8700k?

Chri

almost 7 years

Hy Monsun, sorry but this tool is not compatible with Ivy Bridge.

monsun

almost 7 years

Hi Chri could you provide information about compatiblity with Ivy Bridge CPUs?

Eondar

over 7 years

@ Chri, it was a custom prusa i3. Outside perimeters were printed first. Layerheight was 0,1mm. Infill 25%. However this was probably the 5th print I ever made with the printer, so other settings might have been a little off. If I have the time I could try to print it again without scaling and test it with another cpu. But in general I don't think that it is much of an issue to upscale it a bit. Even if the IHS of the cpu would sit 0,5mm off, the endresult will work without a problem ;)

Chri

over 7 years

@ Eondar, with which printer have you printed it ? Most printer with pre deliveres Settings come with "outside perimeters" last which always causes prints to be larger at outside dimension and smaller at inside dimension. the outside perimeters should be printed at first (even if it becomes more troublesome to overhangs) to get more accurate prints ;)

Eondar

over 7 years

After I printed it at 101% it worked flawlessly. I can't tell if my printer has a little overextrusion or if the tolerances are too tight on this model. Thank you!