Description
I was looking for a light to illuminate the print bed on my UltiMaker when I found the Ikea Jansjo light. It's only €10 and when I got it home I saw that it could be mounted in the UltiMaker itself with a simple block. It uses the screw holes most often used for a carrying handle (sorry, it's this or your handle!) Just screw the lamp to the block with the screws supplied with the lamp, then screw the bloack to the UltiMaker. I used large, M4 washers between the nuts and frame to spread the load a bit.I also made a couple of simple clips to hold the switch that is in the cable on the side of the UltiMaker.
Comments
You need to be signed in before commenting.
UltiErik
over 11 years
Free