Printed in PLA on an Ultimaker 2+ (supports, 0.12mm resolution, 25% infill). I got the best results with the screen printed vertically. To ensure that it remained stable, I put down blue tape on the build plate and wiped the tape down with isopropyl alcohol immediately before the print. This provided excellent adhesion (so good, in fact, that I had to soak it in alcohol again afterwards to get the tape off the part). The rest of the parts were just printed on bare glass. Assembly diagram is included. The whole thing was printed in 3Dom Ingeo PLA. Most of it was printed in white, and then sanded, primed, and then painted; the "power LED" was printed in natural PLA (translucent) and left unpainted; the belt clip was printed in black and left unpainted. - Vallejo Black (ribbed portion on the main case) - Vallejo Basalt Grey (handle, screen, outer bit on the main case part) - Vallejo Neutral Grey under Golden Iridescent Stainless Steel (main case, button) - Testors Gloss Black (camera lens, hat switch) - Behr "Sun Valley" interior house paint (screen) Modeled in Blender, working from numerous screenshots from throughout the first season. I estimated a height of 6 inches (not including the camera housing). If you'd like to print out a screen graphic for display, rather than using a green or blue screen for chromakey, I've included an overlay to composite over your photograph of choice and print, in both SVG and PNG (300 DPI) versions. Inkscape was used to create the graphic.