The wall plate size may be smaller than the real light switch wall plate. You can go to Two Fox Viking themed light switch plate from http://www.thingiverse.com/thing:1833561 for the bigger wall plate. How I printed: In CURA 1 turn off enable retraction option 2 Fill density 100% 3 print speed 45 (mm/s) 4 print temperature 180 My printer is RepRap from the MOST Athena Printer http://www.appropedia.org/Athena_Build_Overview I use PLA red 1.75mm ( the real diameter is 1.94 mm) How I create the model: I download the fox image from https://s-media-cache-ak0.pinimg.com/originals/46/34/60/4634602d5f438f4ff0c5290c86a8d25a.png I use Inkscape to convert 2D cat image to generate path to openSCAD. I use openSCAD to design light switch plate with Key Racks. I open cat.SCAD file in openSCAD and then copied all the code and pasted them into my light switch plate with Key Racks. I use Inkscape to convert 2D image to generate path to openSCAD. The problem is installing the software. My laptop is Mac. I downloaded the Inkscape software from https://inkscape.org/en/learn/books/ I need to download XQuartz software from https://www.xquartz.org/ To use the function OpenSCAD converter from Inkscape, I need to add these two files into Inkscape extension folder from http://www.thingiverse.com/thing:25036 In Mac, these files are hidden. I need to use terminal to find these files and then move them to Inkscape folder by using these commands. mv paths2openscad.py ~/.config/inkscape/extensions/ mv paths2openscad.inx ~/.config/inkscape/extensions/