Standing a flashlight on its tail effectively illuminates a whole room so it's nice to have a flashlight that will stand on its tail.We had a power failure this morning and my flashlight won't stand on its tail, so I was irritated enough to make this.Features a slot that the lanyard can slide down which also provides a bit of relief so that it can slide snugly onto the flashlight even if it's a touch tight.There's a hole in the bottom to press the tailcap switch through.YOU WILL ALMOST CERTAINLY HAVE TO USE THE SCAD FILE, unless your flashlight's tail diameter is very close to 25.5mm diameter, in which case the STL may work for you.To work from the STL, probably all you will need to do is change tail_dia, generate the STL and print it.