RM 2.54 / Breadboard Socket for ESP8266 ESP-07Provided as is.Printed with 0.1mm layer height, using a 0.4mm nozzle.Recommended settings:0.4mm wall thickness, 100% infill, 50mm/sIf the holes aren't clean or are obstructed, use a 1mm drill or just a hot cable to drill through.Instructions:- Print- Drill/clean holes- Fix socket to breadboard with ~2cm long ~0.6mm thick wires- Bend wires 90° to the center- Fix wires with glue (I used crazy glue, but I recommend epoxy. The crazy glue was too fluid, went down the holes and nearly glued my socket to my breadboard!)- Cut remaining wires ~2mm long and bend down ~80°- Place ESP and solder (be quick and careful, the iron will melt the plastic socket, use flux if you have it)