You will need three ~35mm pieces of 8mm rod of your choosing to act as the hinge pin. It also uses 12pcs of heat set M3 inserts for all the screws. To lock the hinge pins in place you will need 3pcs of M3 threaded set screws, i used 6 mm length. I also used five M3x8mm screws with standard washers. Two M6 heat set inserts are used in the press plate for the slider screw. Three countersunk wooden screws are used to fasten it down to a base. For the slider screws, the drawing was made with a partially threaded socket head screw M6x45mm cut down so it only had the smooth part sticking up on top of the insert. I ended up turning this one myself out of a much longer piece of brass for extra stability and the looks. A partially threaded ~M6x130 cut down to only expose ~10mm of thread would also provide this extra stability.