" Machine translation " Embase de bateau - Boat base https://youtu.be/JriVEV5syb0 Boats telecommanded little expensive, created by recovery(recycling) and digital creations. Project of: Thibault and Alain Objective head teacher(main clause): - Creation of two bases of boats mainly established(constituted) by polystyrene and cut with MiniCut2D. - Continuity of a project which consists in creating a boat telecommanded by recovery(recycling) of a toy and rooms(parts,plays) printed in 3D. Simple boat which it makes up(composes,compromises): - Of a car telecommanded to recover where has to buy in attic sale, and of two helixes(propellers). - Of a floating base in polystyrene cut in Minicut2D and possibly for certain wooden rooms(parts,plays) in the cut laser. - Of some rooms(parts,plays) printed in 3D. Peculiarity of the boat A: Three levels are stuck on the wood glue, the lower level has to have a 6 mm thickness has to cut in her(it) minicut2D, Here the middle layer is lined, one in wood (laser cutting) and one in polystyrene (MiniCut2D) Peculiarity of the boat B: The base is at least established(constituted) by two rooms(parts,plays) assembled by a system "dovetail" more glue has wood, this allows to realize a base without being limited by the zone of maximum work of MiniCut2D. It is possible to stick several bases the some on the others and of alténer to strengthen the assembly. Here the base consists of three levels: A small strip inferiors " the skittle " The mileu level of 20 mm (fixation(binding) of inserts) the upper level of 6mm. (The pin of the upper level is stuck on grooves of the level environment(middle)) Remark: a remote-controlled car of type(chap) toy child consists of a central part(party) with the location of accumulators and electronic board of control. It is enough to cut the plastic to get back it under set(group) which is connected to the engine of direction(management) and to the engine of propulsion. See tab Download for the files of 2D cuts (size(format) DXF) and new 3D Link for project of departure and the 3D files: https://www.youmagine.com/designs/boat-in-kit-bateau-en-kit For the fixation(binding) of motor supports in the polystyrene it is advised(recommended) to add the inserts of the link this below: https://www.youmagine.com/designs/fixations-faible-charge-pour-materiaux-tendres