!!! CAUTION !!! • ALL 3D objects created with SketchUpMake. / All Materials usable...This parts printed with: InnoFill and Ultimaker PLA / Layer: 0.1mm / Infill: =>35 Percent / Temp: 215 Degree / Speed: 35>>>70mm/s. • NOTES: For a perfect fit: You can also zoom in Z-axis direction somewhat of these objects. Use the available scaling functions of your preferred slicer. • PLEASE print all items with identical settings. • WARNING: Avoid PLA printing with insufficient infill (less than 33%) in combination with temperatures below 205 degrees. Objects with fine static structures can be very unstable due to poor Layer-Adhesion. Incorrect retraction settings, such as for example too long or too fast retractions can cause big problems in an object with small static elements. • PLEASE use a special printing surface, so your objects get almost smooth and mate base areas, also lower platform temperatures are possible. • PLEASE use the glas printing surface, so your objects get almost glossy base areas. • DIRECT PRINTING ON GLASS: High risk of material Warping and complete detachment from the glass surface, especially for very large objects and insufficient build platform temperatures less than 60 degrees. An excessive build platform temperature higher than 70 degrees, can cause object deformations and dimensional inaccuracies mainly in areas near the glass surface.