EPR InnoPET print temperature 210° build plate temperature 70 ° I have taken the following parameters for the printouts: Earth holder Layer height 0.2mm Wall thickness 1.6mm Infill 30% Build plate adhesion raft Support yes print speed 50 Earth Layer heigth 0.1mm Wall thickness 1.6mm Infill 0% Support yes Build plate adhesion raft print speed 40mm/s Moon holder Layer height 0.2mm Wall thickness 2.8mm Infill 30% Build plate adhesion brim Support none print speed 40mm/s Moon Layer heigth 0.1mm Wall thickness 1.6mm Infill 50% Support none Build plate adhesion brim print speed 40mm/s Adapter earth Layer heigth 0.2mm Wall thickness 1.6mm Infill 30% Support none Build plate adhesion none print speed 50mm/s Slotted screw Layer heigth 0.2mm Wall thickness 1.6mm Infill 30% Support none Build plate adhesion none print speed 50mm/s Hexagon nut Layer heigth 0.2mm Wall thickness 1.6mm Infill 30% Support none Build plate adhesion none print speed 50mm/s rod Layer heigth 0.2mm Wall thickness 1.6mm Infill 30% Support none Build plate adhesion none print speed 50mm/s model holder Layer heigth 0.2mm Wall thickness 1.6mm Infill 30% Support none Build plate adhesion none print speed 50mm/s gear-wheel holder Layer heigth 0.2mm Wall thickness 0.8mm Infill 30% Support none Build plate adhesion none print speed 50mm/s gear-wheel 5 Layer heigth 0.2mm Wall thickness 0.8mm Infill 30% Support none Build plate adhesion none print speed 50mm/s gear-wheel 4 Layer heigth 0.2mm Wall thickness 0.8mm Infill 30% Support none Build plate adhesion none print speed 50mm/s gear-wheel 2/3 Layer heigth 0.2mm Wall thickness 0.8mm Infill 30% Support none Build plate adhesion none print speed 50mm/s gear-wheel 1 Layer heigth 0.2mm Wall thickness 0.8mm Infill 30% Support none Build plate adhesion none print speed 50mm/s