This is a bracket I designed to allow me to use the DiiiCooler with a stock Folgertech Prusa I3. I didn't want to use the two holes on the side of the metal cooler block because I am using those to hold a BLTouch, hence this mount. After several attempts to get this to print as one piece I decided to simply split it into two parts and join them with a screw. Ironically, I think I needed the part cooler in order to get the single piece bracket to print without it curling or drooping too much.If you want to modify the SCAD files in OpenSCAD, make sure you get the threads.scad file (from http://dkprojects.net/openscad-threads/). Also, don't freak out when you go to build it, with the threads enabled it takes quite a while to build.