This stand was created in OpenScad. The scad file has been included so that it can be customized in size as needed. The Wii and Wii-U sensor bar has always required some type of stand. This stand will help to get the sensor bar elevated, no longer will you need to use tape to attach it to the monitor screen. There is a slot in the top of the Nintendo sensor bar. Simply Click the top teeth of this stand into the sensor bar slot and the stand will hold on to the sensor bar tightly. Be sure to feed the sensor bar wire into the back side of the holder. Printing Information: - Layers: 0.25 - Infill: 100% - Print in PLA. - No supports required. Feel free to customize the dimensions of the stand: - The default height of this stand is 90mm. - The default width of this stand is 60mm. A good stable width. - The default wire diameter is 3mm /2. Note: The scad values take into account shrinkage of PLA plastic during cooling. If you wish to modify the wire value, test print a 10mm wide sample of the stand to ensure it works for you. Enjoy!