The OpenScad file has been included. Edit the Lamp Diameter value to suit the mount that you have on hand. - Print in ABS or PLA. - Layers: 0.20 - Infill: 20% - Rafts: No - Supports: No . Remove the screw and hinge pin from the original mount of the webcam for use with this new mount. In this project, a halogen desk lamp was repurposed into a web cam stand. The lamp neck measured 6mm in diameter. This new mount has a 6mm clip which attaches the camera to the lamp. The project includes the following printed parts: - camera mount - camera data cable clips Print these parts: - (1) camera clip mount - (3) or more wire clips The STL files included are suited to a 6mm diameter stick. Remove the small screw from the logitech mount, and then push the long hinge pin out of the logitech mount with a paper clip. Push hard! Trim the extra square flashing off of the long hinge pin so that it is rounded. Reinstall the long hinge pin into the new mount after lining it up with the C210 web cam base. Parts required: - Logitech C210 web cam http://support.logitech.com/en_us/product/webcam-c210 - Halogen desk lamp (pick your own lamp) http://fandangolighthouse.com/brand-dainolite/halogen-desk-lamp/dlha111-sv/sku-25V0H