Camera mount for Raise3D N2 and Logitech C270 webcam. I use this to monitor long prints while out of office or over the weekends. Improvements over the Mk1 inc. grub screw mount for C270 & additional smoothed surfaces on arm joints. Intended future improvements to include mounts for other popular monitoring webcams and servo driven joints. Post-Printing: - Requires M6x25 socket head screws (Qty = Number of Arm Joints +1) & an M6x10mm grub screw. - Recommended M6x1mm tap on the bulge of all joints rather than a printed thread (I find this gives a more reliable fixing). - There are two holes on the base clamp which can be used for further fixing but require the removal of the USB* board. These are not necessary fixings with the C270. NOTE: I recommend NOT using this USB board for power as it has the potential to overload the Raise3D main board. *This has been migrated from my Thingiverse (RIP): https://www.thingiverse.com/thing:3007818 **This contains a .zip of the Mk1 variant