You will need: 1. Some Epoxy 2. A Plastic Bottle Instructions: 1. Print both parts without support. Print the tap with a brim, or else it will probably fall over during the print. 2. Mix up some epoxy and glue the cap to the hole on the tap. Make sure you let it dry for a bit. 3. Drill a hole in a maple tree with a 15/32 inch or 12mm bit, about 5 or 6 cm deep. 4. Push the assembled tap in, wait until some sap starts coming out. It could take a couple minutes. 5.Screw the bottle on and enjoy!