Hey I've started printing this for my bigbox but was wondering if you could post the 3D design files for the parts so i can modify them to the configuration on my bigbox
ccliu
about 8 years
Thanks Richard! I would also like to know the Marlin configuration paramters: X_PROBE_OFFSET_FROM_EXTRUDER, Y_PROBE_OFFSET_FROM_EXTRUDER and Z_PROBE_OFFSET_FROM_EXTRUDER.
RichRap
about 8 years
Hi ccliu, The Z probe uses the same BigBox IR detector system. THis can also be adjusted up and down on the Quick-Fit carriage, so you should be able to set the offset to around 1mm for the V6 or Volcano depending on where you position the sensor.
ccliu
about 8 years
I love your design and will print one. May I know the Z Probe to nozzle offset? Thank you!
Richard Horne (RichRap) is an Electronics Engineer,
Product Designer, Salesman, and Problem Solver working in a wide range of
industries and applications, across many platforms and technologies for the
last 20 years.
My inte...