YouMagine

Information Comments Technical Files

Comments

You need to be signed in before commenting.

area0404

over 9 years

And lots of interaction is needed before the print process. Have yet to try this print but will do it some day.

tomasrey88

over 9 years

Be sure to calibrate the printer with a hearty dinner and fine spirits for a successful print ;0)

UltiErik

almost 10 years

@Carpetsmoker My unit has the same result. Loud noises are normal, except that you can reduce them by putting it into "sleep" mode. The brownish "prints" are reproduced every time (except for some color and viscosity differences). @r2d2: good idea. Apart from these minor issues, I'm having loads of fun with this unit.

r2d3

almost 10 years

@Carpetsmoker: Didn't you read the information about the print before you printed it?? "This is a next generation kind of design (and print), after printing it continues to grow and it becomes interactive." But about this brownish liquid stuff i'm not sure... perhaps it produces some new support material which is water soluble.. so i would keep this stuff for the next print....

Carpetsmoker

almost 10 years

I've printed this. After a while the printed unit then proceeded to make loud noises. Is this normal? It has also started printing this brownish non-descriptive liquid stuff. Is it supposed to do that too?

r2d3

about 10 years

Use a stiff hot end, heat it up to about 40°C and use a lot of retraction to make it... ;-) ;-)

Dim3nsioneer

about 10 years

This print is a true RepRap! :-)