MATERIALS: - YOUR CHOICE! - I USED PLA RECOMMENDED: - FAST PRINT - PVA SUPPORT - 2mm WALL/GROUND/TOP PANEL - 50% INFILL SOCKEL - 0mm BRIM, - 50% INFILL UNTERTEIL - 7mm BRIM - 30% INFILL OBERTEIL - 7mm BRIM - 20% INFILL MONTAGEHILFE - 7mm BRIMM METHODS: DECIDE IF YOU PRINT THE - "ENTIRE SHELL" OR - "TOP AND BOTTOM PART" CHOOSE THE NUMBER OF SNAPS - 9, 6, 3, 2 OR 1 - PLEASE LET ME/THE COMMUNITY KNOW ABOUT YOUR EXPERIENCE GETTING IT APART AGAIN - AND I WILL ADD THE INFORMATION HERE - I HAVE ONLY PRINTED THE 9 SNAPS VERSION, BUT BEWARE - TURNING IT, IS EASY BUT - DOES NOT MATTER IF YOU TURN IT OR NOT - NEVER EVER PUT IT ALL TOGETHER WITHOUT THE PEDESTAL SCREWS IN A SOLID GROUND! - IT`S VERY HARD TO GET IT APART EVEN SCREWED ON A SOLID GROUND! - YOU WILL NEED 2-3 SPATULAS AND COTTERS AND A LOT OF POWER! - IF YOU CHOOSE A PLACE FOR YOUR ECHO DOT, BE AWARE THAT IT IS A DURABLE PLACE - I WOULD ALSO CHOOSE 9 SNAPS WITH CHILDRENS - NEXT TIME I WOULD PRINT 3 SNAPS - AND EVEN 1 SNAP SHOULD BE ENOUGH IF YOU CHOSEN "TOP AND BOTTOM", CHOOSE THE TOP YOU PREFER - "BOLT AND NUT" OR - "NORMAL SCREWS" PRINT ORDER: 1) BOTTOM PART - CAUSE SOLVING THE PVA WILL TAKE THE MOST TIME 2) PEDESTAL - MARK THE ARROW. IT`S THERE BUT HARD TO SEE 3) TOP PART 4) INSTALLATION AID - PRINT THE THINNER END ON TOP SCREWS: - 30mm-35mm SCREWS FOR TOP AND BOTTOM - 04mm THREAD OUTSIDE DIAMETER - COUNTERSUNK HEAD SCREWS - OUTSIDE DIAMETER OF THE BOTTOM HOLE: 04mm - OUTSIDE DIAMETER OF THE TOP HOLE: 3,5mm - 20mm SCREWS FOR THE PEDESTAL - AND WASHERS INSTALLATION: - NO SANDING - MOUNT THE PEDESTAL. THE ARROW SHOWS WHERE THE CABLE WILL BE, AFTER TURNING THE OUTER SHELL - PUT ALEXA INTO THE SHELL. - PUT THE "INSTALLATION AID" THROUGH THE SHELL TILL IT IS HOLDING ECHO DOT IN PLACE - PUT THE HOLE THING ON THE PEDESTAL AT 3 O CLOCK - QUARTER TURN COUNTERCLOCKWISE - CONECT USB CABLE - SCROLL THE PHOTOS BACKWARDS IF YOU NEED HELP CONGRATULATIONS! - YOUR ECHO DOT HAS A SHORTCUT