The multimeter is a 1 piece highly detailed print. As the piece is small it is highly recommended to print with a resin printer to achieve the maximum detail intended. 

Made to look as realistic as possible, the top features an LCD screen with backlight enabled with the “LIGHT” button just below the screen. On the left is the “HOLD” button to temporarily pause the measurements on the screen. The center dial rotates to different modes to measure the voltage, current, and resistance of electrical components. At the bottom of the multimeter are 3 ports to plug the leads into, just like in real life.

As the “1/10” scale is more of a loose standard, feel free to scale up or down in your slicer to fit your own rig, if necessary. 

Same with all of our other print files, it is highly recommended to print only with a resin printer to achieve the maximum amount of details, and do remember to wear PPE.

Post processing is the same with our other products. Use a spray primer depending on your resin type, then either spray paint or hand paint with model paints to your own liking. Top it off with thin coats of UV-proof clear spray.