Introducing our first Vanquish H10 Optic upgrade, our - High Clearance ESC Mount - which allows those who want to run taller ESCs mount them in your H10 without issue. This mount drops the ESC mount - 8mm - (5/16in) while still allowing the stock receiver mount to be used. It does not cause any interface with the rear suspension as it is about level with the rear radiator.

General dimensions: 58mm x 110mm x 5.5mm (L/W/H)

Installation:
You’ll need a 2mm and 2.5mm driver for this install. The “2mm” and “2.5mm” used below are the driver sizes.

Begin by removing the 12 screws - 6 x 2mm and 4 x short 2.5mm from the lower chassis to separate the lower frame from the tube chassis. Note the locations of the shorter 2.5mm screws. You’ll also need to remove the two screws that secure the front of the transmission to the tube chassis.

Optionally you can unmount the shocks (4 2mm screws) as it’ll make things a little easier, but isn’t necessary per say.

With the lower chassis and frame separated, unscrew the ESC mount (4 x 2mm screws) and mount your ESC on the new High Clearance ESC Mount - how you wanna do that is up to you, there are 3 zip tie mounts there as well to help out.

You’ll also need to flip the stock receiver mount so the screws go through the top of the ESC mount and clear the transmission.

Finally, put all the screws back in and check for clearances as you finish up.

-

Don't have a printer and still looking for this mount? Checkout my Etsy store - https://sbiprints.etsy.com/