Introducing our RedCat Ascent Fusion - Full Height Bed - after much group input and full field testing we’re ready to share this bed with everyone!. Our bed includes interchangeable inserts allowing for amazing customizability. We also have scale accessories that were modified specifically for this bed that you can add as well. Our bed sits close enough to the cab that you don't need to run the rear pins, though there is room to insert them from the bottom if needed.

Material: PLA Plus has held up really well in field testing. You could go PETG, but it doesn't seem to be needed at this point. 

Bed Dimensions: 162mm x 140mm x 30mm (48mm along the front for 40mm)

Hardware: You’ll need four M3 x 10mm countersunk screws to secure the insert on to the bed. M3 x 16mm to secure the fuel tanks.

Installation - Full Height Bed:
Begin by securing your chosen insert into the bed and secure it with the supplied hardware.

Next remove the 5 rear cross braces holding the rear of your Ascent Fusion together; note that the ones supporting the suspension are longer. With the cross braces removed slide the three small cross braces into their corresponding holes along the bottom side of the bed. Take one of the longer ones and place that in the circular cut-out (you won’t be able to get to this later).

Finally, place the bed on your truck and reinstall the hardware for the cross braces. Use two 2mm drivers to tighten both ends down equality and if needed reapply thread-lock. 

Don't have a printer and still looking for this bed? Checkout my Etsy store - https://sbiprints.etsy.com/