Parts are oriented in what I think is the best printable positions. Lower rear sections may need a little support but make sure "Bridge Supports " are off. The Cab section Definitely needs supports. Will start test printing really soon but files looks good..

I think I did well with this 80's style Camper van.

Designed for the larger range of 1/10 scale RC trucks this body is 235mm(9.25") wide with a wheelbase of 313mm(12.3").

Has Window trims and window Templates
 Windshield Is included but personally I would use a Polycarbonate sheet unless you are able to print very clear.
 Window template are printed and used to cutout 0.05mm Polycarbonate sheets.
 Light lenses where needed.
 Top marker lights are designed for 2x5x7 rectangular LED's
 Front Headlight Sockets are for 5mm LED's
 Front Signal Light Sockets are for 3mm LED's
 Rear Brake/Reverse/Signal Sockets are for 10mm LED's

Side door will be pried into place and will be openable. 3x5mm Magnets will keep it in place.

The AC unit will need 4 M3x18mm socket cap screws for installation.

I have not yet Test printed it.

Not sure about the interior as it would depend on what chassis it goes on.

If there are any issues please let me know. I will fix them as soon as possible and upload the files.