Minimum print area tested, 220 x 220 x 250 mm / 8,6" x 8,6" x 10,6" inches


Resolution: 0.2mm

Perimeters: 3
Bottom layers: 3
Top layers: 4

Infill: 10%
Supports: Organic or Tree
Adhesion: Use raft or additional supports if you have adhesion issues.

Using low speeds reduces printing defects, it is recommended to use less than 50% of the total speed of your machine.

If you plan to do post-processing of the paint, use 4 or more perimeters


Flexible Tires:
**TPU**

Low speed: approximately 20mm/s
Perimeters: 3
Lower layers: 3
Upper layers: 5
Filling: 0%
Adhesion: No

**I've added a flexible window variation** The window frames are printed in normal filament and the glass in TPU or flexible filament. This is a prototype, so I'll get feedback to improve it.