X-Acto/Hobby knife Phillips #1 Pliers 1. Open up the module with a #1 Phillips screwdriver - at least on mine, they were very tight and using the wrong size will strip the heads very fast. 2. Disconnect the u.fl connector and remove the SMA connector from the top half of the housing. 3. Push the SMA connector up through the bottom entry hole in the printed adapter, screw down the nut and washers to fix it in place, and feed the coax/u.fl connector through the entry tube. 4. Squeeze the adapter housing and press fit the entry tube through the factory hole in the top of the module. 5. Press fit the adapter cap into the bottom entry hole to fix in place.