Print in something strong. I used PRILINE Carbon Fiber Polycarbonate (PC), available here: https://www.amazon.com/gp/product/B074DS3986/ To assemble this, you will need: * 2x M4x12mm button head screws (the 16mm that you use for most of the case are too long) * 2x M4 nuts * 2x M4 washers Take the radio out of the case. Place screws through with the heads on the top end with washers and nuts on the inside of the stand. Put radio back into case and tighten mounting screws through the holes in the bottom of the stand.