YouMagine

Information Comments Technical Files Builds Add build

Comments

You need to be signed in before commenting.

JDM

over 9 years

levlandau;I have been using 12mm rails. I documented the X axis upgrade here: <a href="https://www.flickr.com/photos/34962649@N00/sets/72157647511189303/" target="_blank" rel="nofollow">https://www.flickr.com/photos/34962649@N00/sets/72157647511189303/</a> I had a buddy that got away fine with one rail and one car for the X axis. I was worried about the screws slipping with just one car, and my set included two rails and four cars, so I went all out. Y axis: <a href="https://www.flickr.com/photos/34962649@N00/sets/72157651304651086/" target="_blank" rel="nofollow">https://www.flickr.com/photos/34962649@N00/sets/72157651304651086/</a> Basically, the rails are 12mm width type, and you want to use the low profile cars so that the rail + car height is 13mm. I think these systems will all fit: CPC MR12MN THK SRSR12M THK RSR12ZM THK RSR12VM IKO LWL12BCS IKO LWL12CS NSK LU12 NSK PU12 Hiwin MGN12

levlandau

over 9 years

This is a really cool mod. I really like it. Can you tell me what linear bearings you are using for the x-axis? I really want to upgrade from the standard  bushing which have a good amount of play.

Barrel cooling duct for MendelMax 2 & JD Dually Belt Driven Extruder

By JDM

Comments

License

Tags

JDM

YouMagine

Barrel cooling duct for MendelMax 2 & JD Dually Belt Driven Extruder

By JDM

Add To Collection

Comments

License

Tags

JDM

YouMagine